Guide · winter plumbing
Heat tape for pipes: safe use and a yearly check
Heat tape (also sold as heat cable or pipe heating cable) keeps exposed water pipes in crawl spaces, mobile-home skirting and well pits from freezing. It works, but old, damaged or badly installed tape is a known fire source: in 1996 the U.S. Consumer Product Safety Commission (CPSC) estimated about 1,500 fires, 10 deaths and 100 injuries a year from faulty heat tapes. Newer tapes certified to national standards have a much better safety record. Here is how to use it safely.
Buying heat tape
- Buy tape certified to a recognized safety standard (UL, CSA or FM). The Red Cross also recommends UL-listed heat tape or cable.
- Know the diameter, length and material of the pipe, and buy the tape the manufacturer recommends for it.
- New heat tapes have a 3-prong plug. Plug it into a grounded 3-prong outlet that is protected by a GFCI (ground-fault circuit interrupter).
- CPSC urges replacing uncertified heat tape that is more than 3 years old.
Installing it (follow the instructions for your exact product)
- Apply the tape directly on the pipe, never on top of the insulation covering the pipe.
- Do not wrap or lap the tape over itself unless the manufacturer’s instructions specifically allow it. Instructions differ between types and brands, so reread them when you switch.
- Do not cover the tape with insulation unless the manufacturer says to. If insulation is allowed, use a non-flammable type such as fiberglass, not foam or vinyl, and never more than recommended.
- Keep the end cap sealed and off the ground so water cannot get in.
- If the tape has a thermostat, check whether it should sit against the pipe under insulation or hang free.
- Use water-pipe heat tape only on water pipes, never on gutters, driveways or fuel lines.
Yearly check before winter
- Unplug the tape first.
- Follow the full length, including any you can only reach in the crawl space or under the skirting.
- Look for discolored spots (especially at the plug), charring, cracks, cuts or breaks in the plastic, and bare wires.
- Replace it right away if you find any of those.
- Not comfortable crawling under the house or checking wiring? Have a licensed electrician inspect it.
CPSC investigators found many owners did not know heat tape had been installed in their home at all, so check under the house even if you never put any in. Over half of the heat-tape fires in CPSC’s data involved mobile homes and trailers.
If you don’t have heat tape
Pipe sleeves and insulation, keeping the garage door shut and dripping a faucet on the coldest nights all help. See the frozen pipes checklist, and if a pipe does freeze, thaw it safely.
Common questions
Can heat tape cause a fire?
Yes, when it is old, damaged, overlapped against instructions or covered with flammable insulation. Certified tape installed and inspected per the instructions is much safer.
Does heat tape need a GFCI outlet?
CPSC recommends plugging heat tape into an outlet protected by a ground-fault circuit interrupter (GFCI), using the tape’s grounded 3-prong plug.
Can I put insulation over heat tape?
Only if the manufacturer’s instructions say so, and then only a non-flammable insulation such as fiberglass. Never wrap tape on top of existing pipe insulation.
How often should I replace heat tape?
Replace it whenever the yearly check shows damage. CPSC also urges replacing uncertified heat tape that is more than 3 years old.
Frozen pipes checklist · Thaw a frozen pipe · No water from the well? · All guides
Sources: CPSC: Heat tape guidelines (1996) · CPSC: Check heat tapes and cables for fire hazards · American Red Cross: Frozen Pipes.
Educational information only — not professional advice. For gas, electrical or plumbing work, use your propane retailer, a licensed electrician or a licensed plumber.